| EnviroSep provides Integrated Solutions, nationwide & worldwide, for Fluids Handling, Heat Transfer, and Energy Recovery |
| Call Us @ 843.546.7400 — EnviroSep World Headquarters - Georgetown, South Carolina USA |
your location: Products > Steam & Condensate Systems > Condensate Pump/Trap Combination Package (CPT) (Steam-Pressure-Powered) Model CPT-3
Condensate Pump/Trap Combination Package (CPT) (Steam-Pressure-Powered)
Model CPT - 3
Condensate Pump/Trap Combination Package
(Steam Pressure-Powered)
The Model CPT-3, Condensate Pump/Trap Combination Package, is a manufactured, ready-to-install system designed for installation on single heat transfer sources. The Condensate Pump/Trap Combination Package allows the heat transfer source to operate in a vacuum condition, increasing the heat transfer efficiency. The result is substantial savings in energy costs at attractive pay-back periods. Designed for efficient pumping of condensate, CPT-3 is not vented to atmosphere, therefore there is no additional piping needed for a large vent. The CPT-3 utilizes steam power in lieu of electric motors, eliminating the need for wiring motors, starters, and controls. The steam-powered pump package is capable of operation in flammable environments. Operating by steam pressure versus electric power, reduces pumping costs. The pump employs a float operated snap-acting mechanism with no external seals or packing, which eliminates seal maintenance, which is required in conventional pumps. All internal pump components and mechanism are constructed of stainless steel.
View detailed information on Model CPT-3, Condensate Pump/Trap Combination Package (PDF)
Legend
Approximate Dimensions: 72"H x 66"L x 26"WA. Condensate Inlet 3" NPT
B. Condensate Discharge 2" NPT
C. Air Outlet
D. Steam Inlet ½" NPT
E. Receiver Tank 8"x48"
F. Drain ½" NPT
Brian - a table goes here...
Standard Construction
-
Fabricated Angle Iron Frame
-
Fabricated Steel Tank
-
Bronze Ball Valves
-
Thermodynamic Steam Trap
-
Cast Iron Pump with Gauge Glass, and Stainless Steel internal components and Check Valves
-
Hydrostatically Tested
-
High Temperature Industrial Enamel Paint
Conditions of Operation
Max. Allowable Pressure / Temperature: 125 psig / 450oF
Discharge rate per cycle: 7.1 gal.
Max. instantaneous discharge rate: 90 gpm
Steam Consumption: 3 lbs. per 1000 lbs. of liquid pumped
Compressed Air Consumption: 100 SCF per 1000 lbs. of liquid pumped
System Options
-
Additional / Oversized condensate inlet connection(s)
-
Oversized condensate receiver
-
Oversized atmospheric vent(s)
-
Carbon Steel 3 piece Ball Valves
-
Forged Steel Gate Valves
-
Low-profile design for height restricted applications
-
All Welded piping
-
Fabricated Square Tubing frame
-
Flash Steam Heat Recovery System only without Condensate Inlet for Flash Recovery from existing Atmospheric Tanks.
- Brian
- THESE DOTS are crazy... but Another table goes here: followed by these
notes:
NOTES:
1. Savings are based on max. potential savings at max. pump capacity on 8400 hr./yr. of continuous operation
2. Steam costs at $5.00/MM Btu
3. Savings assume no back pressure on Vented Flash Steam.
4. Water side flow rate based on at 80oF temperature change from 60oF to 140oF.
5. Savings based on approx. calculations -
Quote Request for Model CPT 3
this is where the closing text will go. this is where the primary main body area text will go. this is where the primary main body area text will go. this is where the primary main body area text will go. this is where the primary main body area text will go.