Condensate Pump/Pot Packaged Pumping System (CP) (Base-Mounted End-Suction Centrifugal Pump): Model CP - 60: Fluid Handling, Heat Transfer and Energy Recovery Systems by EnviroSep

Condensate Pump/Pot Packaged Pumping System (CP) (Base-Mounted End-Suction Centrifugal Pump)

Model CP - 60

Legend
Approximate Dimensions: 158"H x 78"L x 48"W

A. Condensate Inlet 10" FLG
B. Condensate Discharge 2" NPT
C. Relief Valve Outlet 4" NPT
D. Pump Drain ½" NPT
E. Receiver Tank 36"x 96"
F. Tank Drain ½" NPT

Condensate Pump / Pot Packaged Pumping (CP) Base-Mounted End-Suction Centrifugal Pump

The Model CP-60, Condensate Pump/Pot, Packaged Pumping System, is a manufactured, ready-to-install system designed for installation on process heat transfer sources. The Condensate Pump/Pot, Packaged Pumping System allows the heat transfer source to operate at optimum conditions by efficiently removing condensate, increasing the heat transfer efficiency. The result is substantial savings in energy costs at attractive pay-back periods because there is no Flash Steam Loss.

Designed for efficient pumping of condensate, CP-60 is not vented to atmosphere, therefore there is no additional piping needed for a large vent. The CP-60 utilizes an End-suction, Base-mounted, ANSI rated, Centrifugal Pump which offers premium pumping of process fluids. The Condensate Pump/Pot is controlled by a proportional level transmitter, which is accessible through top entry, to modulate the discharge control valve, permitting continuous removal of condensate proportional to actual steam consumption. A UL-Listed, Industrial Control Panel is prewired to all electrical sources. The system carries as standard a UL-Listing as a Packaged Pumping System.

View detailed information on Model CP-60, Condensate Pump/Pot, Packaged Pumping System (PDF)

System Options

Additional / Oversized Condensate Inlet connection(s)
Oversized Condensate Receiver
Tank-mounted Pressure Gauge
Reflex Level Gauge Glass
Forged Steel or Cast Steel Gate Valves
Low-profile design for height restricted applications
Condensate Discharge Flowmeter with Panel-mounted Digital Display
Fabricated Square Tubing Frame
Duplex Pump Design with Automatic Secondary Pump Start on Primary Pump Failure
NEMA 4 or 4X Enclosure
All Stainless Steel Construction

Conditions of Operation

Max. Allowable Pressure / Temp: 150 psig / 450 oF
Modulating Discharge Rate: 60 gpm @ 115 ft.
30 ,000 lb/hr @ 115 ft.
Max. Instantaneous Discharge Rate: 180 gpm @ 95 ft.
Electrical Requirements: 15.1 FLA-480 Volts
29.2 FLA-240 Volts
Minimum Recirculation Flow Rate: 45 gpm @ 119 ft.

NOTES:

1. Savings are based on max. potential savings at max. pump capacity on 8400 hr./yr. of continuous operation
2. Steam costs at $5.00/MM Btu
3. Savings based on approx. calculations.
4. Savings are based on the elimination of Flash Loss; Actual savings are derived by actual site conditions.

EnviroSep offers Professional Engineering Service including complete facility, steam, and condensate system layout and design. Regardless of system size, temperature, pressure, fluid medium, or space requirements, EnviroSep can provide solutions to all specialized needs.