Boiler Make-up Reverse Osmosis System: Fluid Handling, Heat Transfer and Energy Recovery Systems by EnviroSep

Boiler Make-Up Water Reverse Osmosis System

The Model BMURO, Boiler Make-up Water Reverse Osmosis System is a fully integrated system which is designed and manufactured to remove up to 99% of the contaminants and impurities (Alkalinity & Conductivity) from the Boiler Make-up Water prior to the Make-up Water blending with Condensate Return. By physical treatment of the Make-up Water to Reverse Osmosis (RO) quality, fuel costs and boiler operating costs are significantly reduced by the reduction of Boiler Blowdown Rate. Reduction in energy consumption is normally expected to be the most significant savings; however, boiler chemical treatment cost reduction can in some cases be as high as fuel savings. Each BMURO system is custom designed and manufactured to meet specific site requirements. All controls are fully integrated into the system via UL-Listed, single-point power connection Industrial Control. All systems are fabricated and welded per ASME Section IX Code and Standards, and are Hydrostatically tested prior to shipment.

View detailed information on Model BMURO,Boiler Make-up Water Reverse Osmosis System (PDF)

Legend A. System Inlet Bag Filtration or Back-washing Strainer B. System Feed Pump C. RO Membrane Housings and Membrane Cartridges D. System Feed and Permeate Flowmeters E. System Pressure Gauges F. UL-Listed Industrial Control Panel G. High Pressure and Low Flow Safety switches
Standard Construction Fabricated Floor-mount Steel Base and Frame Stainless Steel or FRP Membrane Housings Stainless Steel Piping & Valving Cast Iron Pilot-operated Temperature Control Valve with 8ft. capillary tube connected to Temperature Sensor Steam-powered Condensate Pump Motive Steam Connection with Drip Leg Station Pump Exhaust pre-installed Hydrostatically Tested High Temperature Industrial Enamel Paint	Sizing and Selection Units are custom engineered for individual systems, based upon the selection of the system parameters: I. System Flow Rate: Range of 5 gpm to 2,000 gpm II. Inlet Temperature: Range of 40oF to 100oF III. Outlet Temperature: Range of 70oF to 105oF IV. System Pressure: Range of 50 psig to 350 psig V. Dimensions: Based on specific requirements
Conditions of Operation Max. Allowable Pressure: 125 psig Max. Allowable Temperature: 375 oF
Example of Typical Cost Savings
I. System Steam Pressure : 30 psig Make-up Water-side Flow rate: 15.1gpm Water side flow rate based on 80 oF temperature change from 60 oF to 140 oF. Based on continuous system operation of 8400 hr./yr., approximate energy savings are 5100 Million Btu per year. At an estimated steam cost of $5.00 / MM Btu, potential yearly savings are $25,270.00	II. System Steam Pressure : 100 psig Make Water side Flow rate: 45.1gpm Water side flow rate based on 80 oF temperature change from 60 oF to 140 oF. Based on continuous system operation of 8400 hr./yr., approximate energy savings are 15,171 Million Btu per year. At an estimated steam cost of $5.00 / MM Btu, potential yearly savings are $75,858.00

Use our BMURO Online Calculator to estimate Vent Condenser Cost Justifications & Calculated Savings